so someone had told me one time if I deleted a Assembly build for a WO it was like it never happened and the components go back to where they came from. Is this true? I'm working with WIP and Routing now and deleted a Work Order Completion and the associated WO because it was a special WO for 120pc on a 48pc order and for the life of me I couldn't allocate any pieces anywhere. Below is the mess I'm looking at trying to clean up

Was the completion with backflush? I think the step you missed might have been deleting the work order issue but I'm surprised that the work order would let you delete it without doing that first

Bryan I'm not going to lie bud, I'm making myself sick trying to figure this out. I did an inventory adjustment at zero cost to get the negative out but that top Lot with 120 doesn't have a WO attached to it at all which is nuts

I would guess that something consumed the 120 in bin S8 before you deleted the work order completion - either a TO or and IF. Orrrrrr a bin transfer to k25

this is what I have left for the lot that is an issue

Same thing though. so order of events was 1. work order completion (+120)

will that lot vanish then?

Yes

I guess why not at this point

haha, worst case take screen shot of the IT so you can recreate

I have the completed WOC I need to re-enter so after deletion I should make another WO and use the old WOC to clean up

deleting the IA and IT should take you back before the work order completion - whatever you need to do after that is whatever yyou need to do

also am I just sucking up component inventory while doing these?

I'm not sure. if the 120 is a component to be consumed later then yes? maybe?

120 is a finished assembly of a BOM

I see what you are saying

ok I'll run through the motions real quick and see what happens

No problem, I'm an expert in how to un - f inventory problems haha

my life is F'd inventory at the moment